A magic mirror is a stunning piece of furniture and tech but running it constantly draws a lot of power. I am switching mine on and off based on a motion sensor using Home Assistant. Here is how to do that. The Magic Mirror I have described how I built Read more
The stability of your Zigbee network is largely determined by the performance of your coordinator (or router). Switching Zigbee coordinators to a new and better one used to require you to repair all your devices though. With Home Assistant 2022.9 that is a thing of the past. In this post Read more
WLED is a really powerful free software solution to control your LEDs in a smart way. It used to be complicated to set up bit that has changed. Here is how to get your LED setup ready in just five minutes. What is WLED? If you are looking to build Read more
There are a lot of smart relays on the market. The In-Wall Relay Switch Lite from Evvr tries something new: it does not only have a small form factor and very good built quality but also a small “Sub-Assembly” that makes it work with any plain old light switch. I Read more
How do you add an existing doorbell to your smart home? I did it by connecting it to a modified Aqara door sensor. Now a ring will flash lights, send a message to my phone or do anything else I want it to – with all the power of Home Read more
Open source software like Zigbee2MQTT and Home Assistant are a great alternative to (more or less) closed systems like Philips Hue. It can be tricky to get started though. Here is a quick start guide allowing you to use all the advantages like full offline control and the possibility to Read more
Migrating ZHA to a new coordinator can be easy once you figure out how. I have been running my smart home Zigbee network with Home Assistant, ZHA and a Sonoff Zigbee wifi bridge flashed with Tasmota for a couple of years now. With the release of the new cheap and Read more
If you run the supervisor version of Home Assistant (or Home Assistant OS) a backup solution is built-in. If you prefer the more flexible installation via Docker there is no such solution. Here is how to keep regular backups of your Home Assistant configuration when running it in Docker. Running Read more
OctoPrint and your 3D printer can be controlled and monitored by Home Assistant either via an integration or via MQTT. This article will describe the more generic MQTT solution. Connecting OctoPrint to MQTT In another article I have already described how to connect Home Assistant to Octoprint via an integration. Read more
Blueprints are a powerful feature of Home Assistant that makes sharing and using automations simpler. Unfortunately using the target selector in a condition is not supported by default. I needed this for an automation of mine and found a way. Blueprints and the target selector Blueprints are one of the Read more